Measuring Pits

  • Pit Gauge Cat # 5a

    Pit Gauge Cat # 5a

    Undercuts/Pits to 1/2 Inch by 1/32 Inch Increments, able to reach bottom of 1/8” diameter by 1/2″ deep hole

  • Pit Gauge Cat # 5g

    Pit Gauge Cat # 5g

    Undercuts/pits to 0.08″, crowns to 0.04″ by 0.005″ increments. Check undercuts/pits, Crowns, all stainless steel.

  • Pit Gauge Cat # 5f

    Pit Gauge Cat # 5f

    Undercuts/pits to 0-2mm by 0.2mm increments. Check undercuts/Pits, all stainless steel.

  • “V-WAC” Single Weld Gauge Cat # 5m

    “V-WAC” Single Weld Gauge Cat # 5m

    Undercuts/pits to 6mm, crowns to 6mm by 0.5mm increments. Check undercuts/pits, porosity, crowns, all stainless steel.

  • “V-WAC” Single Weld Gauge Cat # 5d

    “V-WAC” Single Weld Gauge Cat # 5d

    Undercuts/pits to 0.240, crowns to 0.240 by 0.020 increments. Check undercuts/pits, porosity, crowns, all stainless steel.

  • “V-WAC” Single Weld Gauge Cat # 5

    “V-WAC” Single Weld Gauge Cat # 5

    Undercuts/pits to 0.240, crowns to 0.240 by 0.020 Increments. Check undercuts/pits, porosity, crowns, all stainless steel.

  • Pocket Bridge Cam Gauge

    Pocket Bridge Cam Gauge

    Check Angle of Preparation, Excess Weld Metal, Depth of Undercut, Depth of Pitting, and more. All stainless steel construction

  • Pipe Pit Gauge

    Pipe Pit Gauge

    Range is 0 to 1/2″ in 1/64″ & .010 increments, arm can be locked in place at any dimension,…

  • Bridge Cam Gauge

    Bridge Cam Gauge

    The following measurements are possible in either inches or millimeters: Angle of Preparation, Excess Weld Metal, Depth of Undercut,…