ASME Basic Cal Block, ¾”
A516-70 Steel

Used for establishment of primary reference responses for UT examination of welds. Block contains three side-drilled holes at 1.5″ deep minimum at 3/32″ diameter. Hole locations through the thickness are ¼, ½, and ¾T. Also contains two EDM notches measuring 2%T deep x 1/4″ max wide x 1.0″ long min. In accordance with ASME Sec V Art. 4 Fig. T-434.2.1.

ASME Basic Calibration Blocks are intended to be representative of actual components, and therefore do not have the smooth scanning surfaces found on most general-purpose test blocks like the IIW or DSC. Instead, our Basic Calibration Blocks are media blasted on all surfaces to create a rough surface texture that is more characteristic of real-world inspection conditions.

  • Dimensions: ¾” thick x 6¼” wide x 4½” long
  • Material: A516-70 Steel, bare
  • Fitted wooden storage case optional…see below.
BloqueASMEGrande

OTROS MATERIALES Y TAMAÑOS

ASME BASIC CAL BLOCK
1/2″, 1 1/2″, 3″

Used for establishment of primary reference responses for UT examination of welds. Block contains three side-drilled holes at 1.5″ deep minimum at 3/32″ diameter. Hole locations through the thickness are ¼, ½, and ¾T. Also contains two EDM notches measuring 2%T deep x 1/4″ max wide x 1.0″ long min. In accordance with ASME Sec V Art. 4 Fig. T-434.2.1.

ASME Basic Calibration Blocks are intended to be representative of actual components, and therefore do not have the smooth scanning surfaces found on most general-purpose test blocks like the IIW or DSC. Instead, our Basic Calibration Blocks are media blasted on all surfaces to create a rough surface texture that is more characteristic of real-world inspection conditions.

  • Materiales disponibles:
    • Type 304 Stainless Steel.
    • 7075-T6 Aluminum, bare.
  • Fitted wooden storage case optional

Long Version ASME Basic Cal Block
1/2″, 3/4″, 1 1/2″, 3″ 

Special long version for 60/70° transducers or phased array. The additional length allows for a full skip to the “top” notch. Used for establishment of primary reference responses for UT examination of welds. Block contains three side-drilled holes at 1.5″ deep minimum at 3/32″ diameter. Hole locations through the thickness are ¼, ½, and ¾T. Also contains two EDM notches measuring 2%T deep x 1/4″ max wide x 1.0″ long min. In accordance with ASME Sec V Art. 4 Fig. T-434.2.1.

  • Dimensions: ¾” thick x 6¼” wide x 6″ long
  • Materiales disponibles:
    • A516-70 Steel, bare.
    • 075-T6 Aluminum, bare.
    • Type 304 Stainless Steel.
  • Hardwood case optional.

SOLICITE MÁS INFORMACIÓN O UNA COTIZACIÓN A UNO DE NUESTROS ASESORES

INFORMACIÓN            COTIZACIÓN